Thursday, March 13, 2008

Drilling Jig for Hubs & Axles

I made this little jig so that I could consistently and easily drill the corresponding holes in the hub and the axles. The jig is made from a piece of old bedframe. Notice that when I drill the hub, I insert one of the AN970 washers

that has been cut to fit the "V" of the jig. When drilling the axle, I remove the washer so that I can accurately drill the correct location that the hub would fit on the axles with just the tip of the axle showing with the outside washer on. Do you understand what I just attempted to say? Ok Fine. :0)

No comments: